|
|
|
|
An excellent choice, with many applications.
Reynobond® with KEVLAR® can be used on the bottom two floors of a structure where large missile impact protection is required, and matched with standard Reynobond on upper floors where only small missile impact protection is required.
| Applications | Reynobond with KEVLAR® | Alcoa-Designed Extrusions | Design Pressure |
 | |||
| Façades<30 feet in height Large Missle Impact Protection Required |
|||
| over Steel Stud Structure 16" on Center | Required | Required | Approved 120 psf |
| over Steel Stud Structure 24" on Center | Required | Required | Approved 90 psf |
| |||
| Façades>30 feet in height Large Missle Impact Protection Required |
|||
| over Steel Stud Structure 16" on Center | Approved Use | Required | Approved 120 psf |
| over Steel Stud Structure 24" on Center | Approved Use | Required | Approved 90 psf |
| |||
A flexible installation solution.
Designed to withstand hurricane-force winds as well as hurricane-windborne debris, the Alcoa-designed extrusions can be fabricated into either a wet seal or aesthetic dry seal joint condition using the same extrusions. The system also allows the flexibility to adjust the joint width to the design specification.
Wet Seal Version
Dry Seal Version
Dry Seal Version
Joint Widths of 1/2" and 3/4" possible
Joint Widths of 3/4" and 1-1/2" possible
Joint Widths of 3/4" and 1-1/2" possible
Note: Dry Seal version requires a bead of caulk in the panel joint creases for Miami-Dade County Product Compliance. Please see the official product approval for details.
Where to Purchase
The Alcoa-designed extrusions, approved by the Miami-Dade Product Compliance Board for use in conjunction with Reynobond with KEVLAR®, are available for direct purchase from distributors. Please contact your Reynobond sales manager for details.
